There are many kinds of materials for 304 stainless steel wire mesh, one is cold drawn steel wire, and of course, galvanized wire, hot dip galvanized wire, wire drawing, and other materials. Surface treatment: hot dip galvanizing, cold dip galvanizing, spray coating. Vibrant meshes are widely used in exhibitions, sample racks, etc.
How to check these raw materials before making 304 stainless steel wire mesh? Let me give you a brief introduction and hope to help everyone.
Before the cold drawing of 304 stainless steel wire mesh, check each indicator, or check with the dynamometer. After confirming the correctness, you can use the steel wire. And make a record during the use process.
After completing the 304 stainless steel wire mesh twice, we should look at the surface for cracks or partial necking. After the cold drawing process, the surface of the steel wire is prone to rust, and rust prevention work should be done.
304 stainless steel wire mesh During use, the cold drawing speed should not be too fast, the belt should be pulled to the specified length or the specified control stress and then stopped. If the welded joint is broken, it can be cold drawn after welding again, no more than twice.
Of course, the inspection should be completed before acceptance, without cracks or mechanical damage.
304 stainless steel wire mesh to check the mechanical properties of the disc cold drawn low carbon steel wire grade.
The six tensile test of cold drawn low carbon steel wire includes two indexes of tensile strength and elongation.
+86-18631958358
